Fastball: Wikis


Note: Many of our articles have direct quotes from sources you can cite, within the Wikipedia article! This article doesn't yet, but we're working on it! See more info or our list of citable articles.


From Wikipedia, the free encyclopedia

During pregame bullpen warmup Chris Young warms up with a four seam fastball.

The fastball (also known as the hummer, the heat, heater, gas, and the cheese), is the most common type of pitch in baseball. Some "power pitchers," such as Nolan Ryan and Roger Clemens, have thrown it at speeds of 95–104 mph (152.9–167.3 km/h) (officially) and up to 107.9 mph (173.6 km/h) (unofficially),[1] relying purely on speed to prevent the ball from being hit. Others throw more slowly but put movement on the ball or throw it on the outside of the plate where the batter cannot easily reach it. The appearance of a faster pitch to the batter can sometimes be achieved by minimizing the batter's vision of the ball before its release. The result is known as an "exploding fastball": a pitch that seems to arrive at the plate quickly despite its low velocity. Fastballs are usually thrown with backspin, so that the Magnus effect creates an upward force on the ball, causing it to fall less rapidly than might be expected. A pitch on which this effect is most marked is often called a "rising fastball", as the ball appears to rise to the batter. Colloquially, use of the fastball is called throwing heat or putting steam on it, among many other variants.

Gripping the ball with the fingers across the wide part of the seam ("four-seam fastball") so that both the index finger and middle finger are touching two seams perpendicularly produces a straight pitch, gripping it across the narrow part ("two-seam fastball") so that both the index finger and middle finger are along a seam produces a sinking fastball, holding a four-seam fastball off-center ("cut fastball") imparts lateral movement to the fastball, and splitting the fingers along the seams ("split-finger fastball") produces a sinking action with a lateral break.



Four-seam fastball

A four-seam fastball is a variant of the fastball.

The four-seam fastball is a pitch that is used often by the pitcher to get ahead in the count or when he needs to throw a strike. The type of fastball is intended to have minimal lateral movement, if any. It is most often the fastest pitch that a pitcher throws, with recorded top speeds in the 100+ mph range. There are two general ways to throw a four-seam fastball.

The first and most traditional way is to find the horseshoe seam area, or the area where the seams are the farthest apart. Keeping those seams parallel to the body, the pitcher places his index and middle fingers perpendicular to them with the pads on the farthest seam from him. The thumb then rests underneath the ball about in the middle of the two fingers. With this grip, the thumb will generally have no seam to rest on.

Two-seam fastball

A two-seam fastball, sometimes called a two-seamer, tailing fastball, or sinker is another variant of the straight fastball.

The two-seam fastball is designed to have more movement than a four-seam fastball so that the batter cannot hit hard, but can be more difficult to master and control. Because of the deviation from the straight trajectory, it is sometimes called a moving fastball.

The pitcher grabs a baseball and finds the area on it where the seams are the closest together, and puts his index and middle fingers on each of those seams. A sinker is a similar pitch thrown with almost the same grip, but with the thumb directly underneath the ball. Sinkers are also thrown slightly slower than two-seamers.[2]

Each finger should be touching the seam from the pads or tips to almost the ball of each finger. The thumb should rest underneath the ball in the middle of those two fingers, finding the apex of the horseshoe part of the seam. The thumb needs to rest on that seam from the side to the middle of its pad. If you use your middle finger when you throw you get more whipping action making the pitch go around 10 mph faster.

This ball will tend to move for the pitcher a little bit depending on velocity, arm slot angle and pressure points of the fingers. Retired pitcher Greg Maddux,was known for his effective two-seamer. Also Derek Lowe of the Atlanta Braves, and Pedro Martínez of the Philadelphia Phillies are known for their particularly effective two-seam fastballs.

Depending on the grip and pressure applied with the fingers, sometimes the two-seam fastball features more sink than lateral movement. Sinkerballers tend to induce a lot of ground ball outs. This is because hitters tend to swing over the ball due to the late downward movement, and thus, often end up beating the ball into the ground. Jake Westbrook and Fausto Carmona of the Cleveland Indians, Greg Maddux, Derek Lowe and Tim Hudson of the Atlanta Braves, Julian Tavarez of the Washington Nationals, Chien-Ming Wang of the New York Yankees, Jason Marquis, Aaron Cook of the Colorado Rockies, Brandon Webb of the Arizona Diamondbacks, Jon Garland of the Los Angeles Dodgers, Roy Halladay and Kyle Kendrick of the Philadelphia Phillies and Bronson Arroyo of the Cincinnati Reds are well known for their sinkers, consistently ranking high in the league in ground ball-to-fly ball ratio.

Rising fastball

The rising fastball is an effect perceived by batters, but is known to be a baseball myth. Some batters claim to have seen a "rising" fastball, which starts as a normal fastball, but as it approaches the plate it rises several inches and gains a burst of speed. Tom Seaver and Dwight Gooden were often described as the paramount pitchers with this kind of ball action.

Such a pitch is known to be beyond the capabilities of pitchers due to the very high backspin that would be required to overcome gravity with the Magnus effect. While not physically impossible (conservation of momentum is maintained through imparting the required opposing momentum to air, as an airplane does at takeoff), the amount of spin required is beyond the capabilities of a human arm. It has been explained as an optical illusion. What is likely happening is that the pitcher first throws a fastball at one speed, and then, using an identical arm motion, throws another fastball at a higher speed. The higher speed fastball arrives faster and sinks less due to its high speed. The added back-spin from the higher speed further decreases the amount of sink. When the pitch is thrown, the batter expects a fastball at the same speed, yet it arrives more quickly and at a higher level. The batter perceives it as a fastball which has risen and increased in speed. A switch from a two-seam to a four-seam fastball can enhance this effect.

This perception may also be created by a tall, hard-throwing pitcher who throws the ball from a higher release point on an elevated mound (the pitcher's rubber is ten inches above the field level). Factoring in the element of depth perception when the hitter watches the pitcher from sixty feet six inches away from the pitcher's mound, and the hitter perceives the pitcher's size and positioning on the mound to be less elevated than it actually is. Hence, to the hitter an overhand pitch will appear to be thrown at a hitter's shoulder level (or even belt level), as opposed to several inches above the hitter's head, from where the pitch is actually released from the pitcher's hand. This perception enhances the apparent "rising" motion of the fastball when the pitch passes the hitter at a higher level than where the hitter perceived the pitch to have left the pitcher's hand.

It is possible for a rising fastball to be thrown by a submarine pitcher because of the technique with which they throw the ball. Because they throw almost underhand with their knuckles near the dirt, the batter perceives the sensation of the ball going upward because of its low starting point and flight trajectory. This is not the traditional rising fastball batters believe they see. This type of movement is similar to a rising fastball in fast-pitch softball. Left-hander Sid Fernandez was known for throwing a rising fastball from a slightly "submarine" motion.


A cut fastball, or "cutter," is similar to a slider, but the pitcher tends to use a four-seam grip. The pitcher shifts the grip on a four-seamer (often by slightly rotating the thumb inwards and the two top fingers to the outside) to create more spin. This usually causes the pitch to shift inwards or outwards by a few inches, less than a typical slider, and often late. A cutter is effective for pitchers with a strong four-seamer since the grip and delivery look virtually identical. The unexpected motion will fool batters into hitting the ball off-center, or missing it altogether.

Mariano Rivera, a relief pitcher for the New York Yankees, is a pitcher known for throwing a cutter. Rivera can deliver late motion while throwing the ball around 95 mph. Al Leiter rode his cutter to 162 career wins and a no-hitter. Jamie Moyer currently with the Philadelphia Phillies throws an effective cut fastball at the age of 46. Esteban Loaiza used a cutter to help him win 21 games in 2003. Roy Halladay of the Philadelphia Phillies also throws a cut fastball, but claims that overusing it has given him forearm trouble [1] which may have prematurely ended Halladay's 2006 season due to forearm stiffness, since the grip causes more stress than a standard four-seamer. Yankee Andy Pettitte is another pitcher who throws the cutter. On a June 3, 2007 game against the Boston Red Sox, announcer Joe Morgan estimated that of Pettite's 87 pitches, 83 of them were cutters.

As of mid-August 2009, Scott Feldman had the most effective cut fastball in all of baseball in 2009.[3] And it was the third-most-effective pitch in the major leagues, behind only Tim Lincecum’s change-up and Clayton Kershaw’s fastball.[3] While in 2008 he used his cutter 13.4% of the time, in 2009 he was throwing it 30.4% of the time.[3] The only starting pitchers who were throwing cutters more often were Brian Bannister, Doug Davis, and Halladay.[3]

Split-finger fastball

The split-finger fastball or "splitter," is thrown with the same arm motion as a normal fastball, but the adjusted grip causes it to behave quite differently. The ball does not have the characteristically tight spin of a fastball. The ball appears to tumble in a knuckleball-like fashion; but it is much faster than a knuckleball. The ball is gripped tightly with the index and middle finger "split" along the outside of the horseshoe seam. It is important that these two fingers are not touching any seams - it should be on a smooth part of the ball. Since these two fingers are off to the side of the ball, there is some slippage at release. This is desirable because it is this slippage that robs the ball of spin and causes it to run out of energy and dart randomly as it approaches the batter. A splitter will usually drop as it approaches the plate, and break to either the right or left. The split-finger fastball is often most effective when it is located outside of the strike zone; the pitch starts in the strike zone and then falls out of it, causing batters to "chase" the pitch. The forkball is a similar pitch, though it is slower and gripped with a more exaggerated split of the fingers. A pitcher generally needs long fingers to effectively throw this pitch. Due to similarities in speed and movement, some pitcher's split-finger fastballs are misappropriated as changeups.

It is very difficult to control and is stressful on the arm. The reason it is so stressful is that there is tension created in the upper arm as a result of the drastic split of the fingers. This has a tendency to lock the wrist up and prevents there from being any shock absorption at release.

The split-finger is used currently by pitchers such as Chien-Ming Wang, Dan Haren, Kelvim Escobar, José Contreras, Jake Robbins, Jonathan Papelbon, Curt Schilling, Junichi Tazawa, Jeremy Accardo, J. J. Putz and John Smoltz. Former players noted for use of the split-finger fastball include Jack Morris, Mike Scott, Kazuhiro Sasaki, Bryan Harvey, Bruce Sutter, Jeremy Accardo and Roger Clemens.


The Incurve was a term used until about 1930 used to describe a simple fastball. As a curveball was often called an "outcurve," one might assume that an incurve is the opposite of a curveball, in other words, the modern screwball. However, this does not appear to be so, as cited by John McGraw.

All balls that are twisted out of their natural course are called curves. The outcurve, the drop, down shoot, and so on, are simply a curve ball to the professional player. To us there is no such thing as an incurve. That is what we call a fastball. Of course, I am assuming the pitcher is right-handed. A so-called incurve is nothing more than a ball thrown in a natural way with great force. A ball thus thrown will naturally curve inward, to a certain extent.[4]

Side-arm fastball

A side-arm fast ball is thrown from an angle different from the normal one. It is at a lower angle and is thrown from the side, hence the name "side"-arm. It will have a sinking motion to the right if it is a right hand pitcher, or to the left if it is a left hand pitcher. It is usually slower than a normal four-seam fastball.


  1. ^ Baseball Almanac. ""The Fastest Pitcher in Baseball History"". Retrieved 2007-08-10. 
  2. ^ Zack Hample (2007). Watching Baseball Smarter. Vintage Books/Random House (USA). 
  3. ^ a b c d Manning, Erik (8/12/09). "The Evolution of Scott Feldman". Fangraphs. Retrieved 2009-08-15. 
  4. ^ John J. McGraw, My Thirty Years in Baseball.

Got something to say? Make a comment.
Your name
Your email address