Food processing: Wikis

  

Note: Many of our articles have direct quotes from sources you can cite, within the Wikipedia article! This article doesn't yet, but we're working on it! See more info or our list of citable articles.

Encyclopedia

From Wikipedia, the free encyclopedia

Food processing is the set of methods and techniques used to transform raw ingredients into food or to transform food into other forms for consumption by humans or animals either in the home or by the food processing industry. Food processing typically takes clean, harvested crops or slaughtered and butchered animal products and uses these to produce attractive, marketable and often long shelf-life food products. Similar process are used to produce animal feed.

Extreme examples of food processing include the delicate preparation of deadly fugu fish or preparing space food for consumption under zero gravity.

Contents

Food processing methods

Common food processing techniques include:

History

Food processing dates back to the prehistoric ages when crude processing incorporated slaughtering, fermenting, sun drying, preserving with salt, and various types of cooking (such as roasting, smoking, steaming, and oven baking). Salt-preservation was especially common for foods that constituted warrior and sailors' diets, up until the introduction of canning methods. Evidence for the existence of these methods exists in the writings of the ancient Greek , Chaldean, Egyptian and Roman civilizations as well as archaeological evidence from Europe, North and South America and Asia. These tried and tested processing techniques remained essentially the same until the advent of the industrial revolution. Examples of ready-meals also exist from pre industrial revolution times such as the Cornish pasty and the Haggis

Modern food processing technology in the 19th and 20th century was largely developed to serve military needs. In 1809 Nicolas Appert invented a vacuum bottling technique that would supply food for French troops, and this contributed to the development of tinning and then canning by Peter Durand in 1810. Although initially expensive and somewhat hazardous due to the lead used in cans, canned goods would later become a staple around the world. Pasteurization, discovered by Louis Pasteur in 1862, was a significant advance in ensuring the micro-biological safety of food.

In the 20th century, World War II, the space race and the rising consumer society in developed countries (including the United States) contributed to the growth of food processing with such advances as spray drying, juice concentrates, freeze drying and the introduction of artificial sweeteners, colouring agents, and preservatives such as sodium benzoate. In the late 20th century products such as dried instant soups, reconstituted fruits and juices, and self cooking meals such as MRE food ration were developed.

In western Europe and North America, the second half of the 20th century witnessed a rise in the pursuit of convenience, food processors especially marketed their products to middle-class working wives and mothers. Frozen foods (often credited to Clarence Birdseye) found their success in sales of juice concentrates and "TV dinners". [1] Processors utilised the perceived value of time to appeal to the postwar population, and this same appeal contributes to the success of convenience foods today.

Benefits

Mass production of food is much cheaper overall than individual production of meals from raw ingredients. Therefore, a large profit potential exists for the manufacturers and suppliers of processed food products. Individuals may see a benefit in convenience, but rarely see any direct financial cost benefit in using processed food as compared to home preparation. Poor quality ingredients and sometimes questionable processing and preservation methods detract greatly from the overall benefit gained by individual consumers.

More and more people live in the cities far away from where food is grown and produced. In many families the adults are working away from home and therefore there is little time for the preparation of food based on fresh ingredients. The food industry offers products that fulfil many different needs: From peeled potatoes that only have to be boiled at home to fully prepared ready meals that can be heated up in the microwave oven within a few minutes.

Benefits of food processing include toxin removal, preservation, easing marketing and distribution tasks, and increasing food consistency. In addition, it increases seasonal availability of many foods, enables transportation of delicate perishable foods across long distances, and makes many kinds of foods safe to eat by de-activating spoilage and pathogenic micro-organisms. Modern supermarkets would not be feasible without modern food processing techniques, long voyages would not be possible, and military campaigns would be significantly more difficult and costly to execute.

Modern food processing also improves the quality of life for people with allergies, diabetics, and other people who cannot consume some common food elements. Food processing can also add extra nutrients such as vitamins.

Processed foods are often less susceptible to early spoilage than fresh foods, and are better suited for long distance transportation from the source to the consumer. Fresh materials, such as fresh produce and raw meats, are more likely to harbour pathogenic micro-organisms (e.g. Salmonella) capable of causing serious illnesses.

Drawbacks

In general, fresh food that has not been processed other than by washing and simple kitchen preparation, may be expected to contain a higher proportion of naturally-occurring vitamins, fiber and minerals than an equivalent product processed by the food industry. Vitamin C, for example, is destroyed by heat and therefore canned fruits have a lower content of vitamin C than fresh ones.

Food processing can lower the nutritional value of foods, and introduce hazards not encountered with naturally-occurring products. Processed foods often include food additives, such as flavourings and texture-enhancing agents, which may have little or no nutritive value, or be unhealthy. Preservatives added or created during processing to extend the 'shelf-life' of commercially-available products, such as nitrites or sulphites, may cause adverse health effects. Use of low-cost ingredients that mimic the properties of natural ingredients (e.g. cheap chemically-hardened vegetable oils in place of more-expensive natural saturated fats or cold-pressed oils) have been shown to cause severe health problems, but are still in widespread use because of cost concerns and lack of consumer knowledge about the effects of substitute ingredients.

Processed foods often have a higher ratio of calories to other essential nutrients than unprocessed foods, a phenomenon referred to as "empty calories". So-called junk food, produced to satisfy consumer demand for convenience and low cost, are most often mass-produced processed food products.

Because processed food ingredients are often produced in high quantities and distributed widely amongst value-added food manufacturers, failures in hygiene standards in 'low-level' manufacturing facilities that produce a widely-distributed basic ingredient can have serious consequences for many final products. Consequently, adequate government regulation of ingredient manufacturers is an essentially important factor in securing the production of generally-safe processed foods. Blame for failures in the process of food safety regulation therefore often fall on the governmental department entrusted with this task.

Performance parameters for food processing

When designing processes for the food industry the following performance parameters may be taken into account:

  • Hygiene, e.g. measured by number of micro-organisms per ml of finished product
  • Energy consumption, measured e.g. by “ton of steam per ton of sugar produced”
  • Minimization of waste, measured e.g. by “percentage of peeling loss during the peeling of potatoes'
  • Labour used, measured e.g. by ”number of working hours per ton of finished product”
  • Minimization of cleaning stops measured e.g. by “number of hours between cleaning stops”

Trends in modern food processing

Cost reduction

  • Profit Incentive drives most of the factors behind any industry; the food industry not least of all. Health concerns are generally subservient to profit potential, leading the food processing industry to often ignore major health concerns raised by the use of industrially-produced ingredients (partially-hydrogenated vegetable oils, for example, a well-known and well-researched cause of heart disease, that is still commonly used in processed food to increase profit margin.) Consumer pressure has led to a reduction in the use of industrially-produced ingredients in processed food, but the (often slight) potential for increased profits has barred widespread acceptance by the industry of recognized health problems caused by over-consumption of processed foods.

Health

  • Reduction of fat content in final product e.g. by using baking instead of deep-frying in the production of potato chips, another processed food
  • Maintaining the natural taste of the product e.g. by using less artificial sweetener than they used before...

Hygiene

The rigorous application of industry and government endorsed standards to minimise possible risk and hazards. In the USA the standard adopted is HACCP. Lims solutions help industry to manage those quality standards.

Efficiency

  • Rising energy costs lead to increasing usage of energy-saving technologies[2], e.g. frequency converters on electrical drives, heat insulation of factory buildings and heated vessels, energy recovery systems, keeping a single fish frozen all the way from China to Switzerland
  • Factory automation systems (often Distributed control systems) reduce personnel costs and may lead to more stable production results

Industries

Food processing industries and practices include the following:

See also

References

  1. ^ Levenstein, H: "Paradox of Plenty", pages 106-107. University of California Press, 2003
  2. ^ STAC - Project Information Center - 03-STAC-01 - Western U. S. Food Processing Efficiency Initiative

Other sources

  • Fábricas de alimentos, 9th edition (in Spanish)
  • Nutritional evaluation of food processing,
  • Food preservation 2nd edition, by Normal W. Desrosier

External links


Simple English

Food processing means the ways that are used to change raw ingredients into food so that they can be eaten by humans or animals. The food processing industry uses these processes. Food processing often takes clean, harvested or slaughtered and butchered components and uses these to produce attractive and marketable food products. Similar process are used to produce animal feed.

Industries

Food processing industries and practices include the following:

Related pages

Other websites









Got something to say? Make a comment.
Your name
Your email address
Message