The Full Wiki

More info on Microalloyed steel

Microalloyed steel: Wikis


Note: Many of our articles have direct quotes from sources you can cite, within the Wikipedia article! This article doesn't yet, but we're working on it! See more info or our list of citable articles.


From Wikipedia, the free encyclopedia

Microalloyed steel is a type of alloy steel that contains small amounts of alloying elements (0.05 to 0.15%). Standard alloying elements include: niobium, vanadium, titanium, molybdenum, zirconium, boron, and rare-earth metals. They are used to refine the grain microstructure and/or facilitate precipitation hardening.[1]

These steels performance and cost land between carbon steel and low alloy steel. Yield strength is between 500 and 750 MPa (73,000 and 110,000 psi) without heat treatment. Weldability is good, and can even be improved by reducing carbon content while maintaining strength. Fatigue life and wear resistance are superior to similar heat treated steels. The disadvantages are that ductility and toughness are not as good as quenched and tempered (Q&T) steels. They must also be heated hot enough for the all of the alloys to be in solution; after forming the material must be quickly cooled to 540 to 600 °C (1,004 to 1,112 °F).[2]

Cold worked microalloyed steels do not require as much cold working to achieve the same strength as other carbon steel; this also leads to greater ductility. Hot worked microalloyed steels can be used from the air cooled state. If controlled cooling is used, the material can produce mechanical properties similar to Q&T steels. Machinability is better than Q&T steels because of their more uniform hardness and their ferrite-pearlite microstructure.[3]

Because microalloyed steels are not quenched and tempered they are not susceptible to quench cracking, nor do they need to be straightened or stress relieved. However, because of this they are through hardened and do not have a softer and tougher core like quench and tempered steels.[3]




  1. ^ Degarmo, p. 116.
  2. ^ Degarmo, pp. 116–117.
  3. ^ a b Degarmo, p. 117.


  • Degarmo, E. Paul; Black, J T.; Kohser, Ronald A. (2003), Materials and Processes in Manufacturing (9th ed.), Wiley, ISBN 0-471-65653-4  .


Got something to say? Make a comment.
Your name
Your email address