Molecular vibration: Wikis

Advertisements
  
  

Note: Many of our articles have direct quotes from sources you can cite, within the Wikipedia article! This article doesn't yet, but we're working on it! See more info or our list of citable articles.

Encyclopedia

Advertisements

From Wikipedia, the free encyclopedia


A molecular vibration occurs when atoms in a molecule are in periodic motion while the molecule as a whole has constant translational and rotational motion. The frequency of the periodic motion is known as a vibration frequency. A nonlinear molecule with n atoms has 3n−6 normal modes of vibration, whereas a linear molecule has 3n−5 normal modes of vibration because rotation about its molecular axis cannot be observed[1]. A diatomic molecule thus has one normal mode of vibration. The normal modes of vibration of polyatomic molecules are independent of each other, each involving simultaneous vibrations of different parts of the molecule.

A molecular vibration is excited when the molecule absorbs a quantum of energy, E, corresponding to the vibration's frequency, ν, according to the relation E=hν, where h is Planck's constant. A fundamental vibration is excited when one such quantum of energy is absorbed by the molecule in its ground state. When two quanta are absorbed the first overtone is excited, and so on to higher overtones.

To a first approximation, the motion in a normal vibration can be described as a kind of simple harmonic motion. In this approximation, the vibrational energy is a quadratic function (parabola) with respect to the atomic displacements and the first overtone has twice the frequency of the fundamental. In reality, vibrations are anharmonic and the first overtone has a frequency that is slightly lower than twice that of the fundamental. Excitation of the higher overtones involves progressively less and less additional energy and eventually leads to dissociation of the molecule, as the potential energy of the molecule is more like a Morse potential.

The vibrational states of a molecule can be probed in a variety of ways. The most direct way is through infrared spectroscopy, as vibrational transitions typically require an amount of energy that corresponds to the infrared region of the spectrum. Raman spectroscopy, which typically uses visible light, can also be used to measure vibration frequencies directly.

Vibrational excitation can occur in conjunction with electronic excitation (vibronic transition), giving vibrational fine structure to electronic transitions, particularly with molecules in the gas state.

Simultaneous excitation of a vibration and rotations gives rise to vibration-rotation spectra.

Contents

Vibrational coordinates

The coordinate of a normal vibration is a combination of changes in the positions of atoms in the molecule. When the vibration is excited the coordinate changes sinusoidally with a frequency ν, the frequency of the vibration.

Internal coordinates

Internal coordinates are of the following types, illustrated with reference to the planar molecule ethylene,

Ethylene
  • Stretching: a change in the length of a bond, such as C-H or C-C
  • Bending: a change in the angle between two bonds, such as the HCH angle in a methylene group
  • Rocking: a change in angle between a group of atoms, such as a methylene group and the rest of the molecule.
  • Wagging: a change in angle between the plane of a group of atoms, such as a methylene group and a plane through the rest of the molecule,
  • Twisting: a change in the angle between the planes of two groups of atoms, such as a change in the angle between the two methylene groups.
  • Out-of-plane: Not present in ethene, but an example is in BF3 when the boron atom moves in and out of the plane of the three fluorine atoms.

In a rocking, wagging or twisting coordinate the angles and bond lengths within the groups involved do not change. Rocking is distinguished from wagging by the fact that the atoms in the group stay in the same plane.

In ethene there are 12 internal coordinates: 4 C-H stretching, 1 C-C stretching, 2 H-C-H bending, 2 CH2 rocking, 2 CH2 wagging, 1 twisting. Note that the H-C-C angles cannot be used as internal coordinates as the angles at each carbon atom cannot all increase at the same time.

See infrared spectroscopy for some animated illustrations of internal coordinates.

Symmetry-adapted coordinates

Symmetry-adapted coordinates may be created by applying a projection operator to a set of internal coordinates.[2] The projection operator is constructed with the aid of the character table of the molecular point group. For example, the four(un-normalised) C-H stretching coordinates of the molecule ethene are given by

Qs1 = q1 + q2 + q3 + q4
Qs2 = q1 + q2 - q3 - q4
Qs3 = q1 - q2 + q3 - q4
Qs4 = q1 - q2 - q3 + q4

where q1 - q4 are the internal coordinates for stretching of each of the four C-H bonds.

Illustrations of symmetry-adapted coordinates for most small molecules can be found in Nakamoto.[3]

Normal coordinates

A normal coordinate, Q, may sometimes be constructed directly as a symmetry-adapted coordinate. This is possible when the normal coordinate belongs uniquely to a particular irreducible representation of the molecular point group. For example, the symmetry-adapted coordinates for bond-stretching of the linear carbon dioxide molecule, O=C=O are both normal coordinates:

  • symmetric stretching: the sum of the two C-O stretching coordinates; the two C-O bond lengths change by the same amount and the carbon atom is stationary. Q = q1 + q2
  • asymmetric stretching: the difference of the two C-O stretching coordinates; one C-O bond length increases while the other decreases. Q = q1 - q2

When two or more normal coordinates belong to the same irreducible representation of the molecular point group (colloquially, have the same symmetry) there is "mixing" and the coefficients of the combination cannot be determined a priori. For example, in the linear molecule hydrogen cyanide, HCN, The two stretching vibrations are

  1. principally C-H stretching with a little C-N stretching; Q1 = q1 + a q2 (a << 1)
  2. principally C-N stretching with a little C-H stretching; Q2 = b q1 + q2 (b << 1)

The coefficients a and b are found by performing a full normal coordinate analysis by means of the Wilson GF method.[4]

Newtonian mechanics

Perhaps surprisingly, molecular vibrations can be treated using Newtonian mechanics, to calculate the correct vibration frequencies. The basic assumption is that each vibration can be treated as though it corresponds to a spring. In the harmonic approximation the spring obeys Hooke's law: the force required to extend the spring is proportional to the extension. The proportionality constant is known as a force constant, k. The anharmonic oscillator is considered elsewhere.[5]

\mathrm{Force}=- k Q \!

By Newton’s second law of motion this force is also equal to a "mass", m, times acceleration.

 \mathrm{Force} = m \frac{d^2Q}{dt^2}

Since this is one and the same force the ordinary differential equation follows.

m \frac{d^2Q}{dt^2} + k Q = 0

The solution to this equation of simple harmonic motion is

Q(t) = A \cos (2 \pi \nu t) ;\ \ \nu = {1\over {2 \pi}} \sqrt{k \over m} \!

A is the maximum amplitude of the vibration coordinate Q. It remains to define the "mass", m. In a homonuclear diatomic molecule such as N2, it is half the mass of one atom. In a heteronuclear diatomic molecule, AB, it is the reduced mass, μ given by

\frac{1}{\mu} = \frac{1}{m_A}+\frac{1}{m_B}

The use of the reduced mass ensures that the centre of mass of the molecule is not affected by the vibration. In the harmonic approximation the potential energy of the molecule is a quadratic function of the normal coordinate. It follows that the force-constant is equal to the second derivative of the potential energy.

f=\frac{\partial ^2V}{\partial Q^2}

When two or more normal vibrations have the same symmetry a full normal coordinate analysis must be performed (see GF method). The vibration frequencies,νi are obtained from the eigenvalues,λi, of the matrix product GF. G is a matrix of numbers derived from the masses of the atoms and the geometry of the molecule.[4] F is a matrix derived from force-constant values. Details concerning the determination of the eigenvalues can be found in [6].

Quantum mechanics

In the harmonic approximation the potential energy is a quadratic function of the normal coordinates. Solving the Schrödinger wave equation, the energy states for each normal coordinate are given by

E_n = \left( n + {1 \over 2 } \right) h {1\over {2 \pi}} \sqrt{k \over m} \!,

where n is a quantum number that can take values of 0, 1, 2 ... The difference in energy when n changes by 1 are therefore equal to the energy derived using classical mechanics. See quantum harmonic oscillator for graphs of the first 5 wave functions. Knowing the wave functions, certain selection rules can be formulated. For example, for a harmonic oscillator transitions are allowed only when the quantum number n changes by one,

\Delta n = \pm 1

but this does not apply to an anharmonic oscillator; the observation of overtones is only possible because vibrations are anharmonic. Another consequence of anharmonicity is that transitions such as between states n=2 and n=1 have slightly less energy than transitions between the ground state and first excited state. Such a transition gives rise to a hot band.

Intensities

In an infrared spectrum the intensity of an absorption band is proportional to the derivative of the molecular dipole moment with respect to the normal coordinate.[7] The intensity of Raman bands depends on polarizability. See also transition dipole moment.

See also

References

  1. ^ Landau LD and Lifshitz EM (1976) Mechanics, 3rd. ed., Pergamon Press. ISBN 0-08-021022-8 (hardcover) and ISBN 0-08-029141-4 (softcover)
  2. ^ F.A. Cotton Chemical applications of group theory, Wiley, 1962, 1971
  3. ^ K. Nakamoto Infrared and Raman spectra of inorganic and coordination compounds, 5th. edition, Part A, Wiley, 1997
  4. ^ a b E.B. Wilson, J.C. Decius and P.C. Cross, Molecular vibrations, McGraw-Hill, 1955. (Reprinted by Dover 1980)
  5. ^ S. Califano, Vibrational states, Wiley, 1976
  6. ^ P. Gans, Vibrating molecules, Chapman and Hall, 1971
  7. ^ D. Steele, Theory of vibrational spectroscopy, W.B. Saunders, 1971

Further reading

  • P.M.A. Sherwood, Vibrational spectroscopy of solids, Cambridge University Press, 1972

External links


Advertisements






Got something to say? Make a comment.
Your name
Your email address
Message